Office Chair Installation - Leather Chair

The installation steps for different styles of office leather chairs are as follows:

Zhu Fu Bow-shaped P-style Leather Chair

1. Install the lower frame and seat cushion: After receiving the components, first install the lower frame onto the seat cushion. Before installation, clean the screw holes to ensure no debris affects the installation. Use an Allen wrench to tighten the screws, and the installation method is the same for both the left and right sides.
2. Install the connecting rod: Install the connecting rod at the bottom of the lower frame. There are corresponding screw holes on both sides of the lower frame. Since the space in the lower frame may be relatively cramped, pull hard on the connecting rod during installation to align it with the screw holes and then tighten it.
3. Install the armrests: Install the armrests onto the holes on the seat cushion and backrest. Also, use an Allen wrench to tighten the screws to ensure the armrests are firmly installed.
4. Install the headrest bracket and headrest: Install the headrest bracket onto the iron plate on the backrest and tighten it with a triangular cover. Finally, snap the headrest onto the headrest bracket to complete the installation.

908/909 Office Chair

1. Install the casters and gas lift: First, insert the five casters into the five-star base, and then install the gas lift.
2. Install the backrest bracket: Use 4 M6*25mm screws to install the backrest bracket.
3. Connect the backrest and seat pan: Use 3 M8*20mm screws to connect the backrest and the seat pan.
4. Insert the gas lift: Insert the installed gas lift into the hole on the seat pan.
5. Install the armrests: Use 2 M8*25mm screws to install the left and right armrests. This step needs to be repeated twice to ensure that the armrests on both sides are properly installed.
6. Install the headrest: Use an M6*25mm screw to install the headrest.
7. Install the footrest: Put 2 rubber rings on the footrest, and then use 2 M8*25mm screws to install the left and right armrests (the repetition of the armrest installation step here may be due to specific design requirements).

Maidang Piel Chair

1. Install the armrests and connecting plates: Use an Allen wrench and long screws. First, assemble the left armrest with the connecting plate, put the nut in advance, align the hole positions, insert the long screws, and tighten them slightly. Do the same on the other side of the connecting plate. Then, install the other connecting plate in the same way.
2. Install the back cushion: Align the hole positions of the frame and the back cushion, insert medium-sized screws and tighten them, but be careful not to tighten them too much. Do the same on the other side.
3. Install the seat cushion: After placing the seat cushion properly, turn it over, hold it with your hands, and insert wood screws into the corresponding hole positions and tighten them.