Office Chair Image and Installation Guide

The installation steps for office chairs vary depending on the brand and model. Here is a detailed introduction to the installation methods for common office chairs:

TOAI E1 Office Chair Installation Steps

• Install Wheels and Gas Lift: First, press the wheels into the chair legs to ensure they are securely installed. Then, place the gas lift into the middle hole of the chair base. Pay attention to the direction of the gas lift to ensure it can rise and fall normally.
• Connect Seat and Backrest: Take out the seat and backrest, and use three M8 screws to fix the backrest and tighten them to ensure a tight connection between the backrest and the seat, preventing looseness.
• Install Armrests: Connect the armrests to the seat, flip the chair seat over, and secure the other armrest. Pay attention to the position and angle of the armrests during installation to ensure comfort during use.
• Install Footrest: Take the footrest and insert it into the hole below the seat to ensure the footrest can extend and retract normally and be used properly.
• Install Gas Lift and Base: Align the gas lift with the base and insert it to make the overall structure of the chair more stable.
• Install Headrest: Finally, insert the headrest into the backrest, and the chair installation is complete.

Deli Office Chair Installation Steps

• Install Ball Bearings: Press the ball bearings into the corresponding positions to ensure they can roll flexibly.
• Place Seat and Screws: Place the underside of the seat properly, push the screws up, and then place the relevant components on top.
• Install Screws and Backrest: Install the screws according to the indicated arrows. First, install some of the screws, then install the backrest, and finally install the decorative cover to make the chair look more aesthetically pleasing.

General Office Chair Installation Steps

• Install Casters and Gas Rod: First, install the casters one by one onto the chair legs. After installing the chair legs, place the gas rod vertically into the center of the chair legs to ensure the gas rod is vertical and stable.
• Secure Base: Fix the base to the seat with screws, paying attention to the tightness of the screws to prevent the base from loosening.
• Connect Backrest and Seat: After the seat is installed, connect the backrest and the seat to ensure a tight connection.
• Install Pedestal: Insert the pedestal vertically onto the gas rod to enable the chair to rise and fall normally.
• Install Armrests and Headrest: Finally, install the armrests and headrest to complete the installation.

Multifunctional Computer Chair Installation Steps

• Install Casters and Lift Rod: Directly clamp the movable casters onto the five-star base, flip it over, and insert the lift rod into the middle hole of the five-star base, then fasten the computer chair tray.
• Install Backrest: Install the backrest bracket, install the backrest mesh, and fix it with a few screws to ensure the stability of the backrest.
• Install Armrests and Decorations: Install the armrests on both sides, making sure not to install them backwards. Finally, tighten all the screws, snap on the black decorative buttons and the diamond-shaped decorative panel on the back of the backrest.