Office Chair Assembly Drawing

Currently, there is no directly provided complete office chair assembly drawing file, but assembly can be assisted by detailed assembly step instructions, and relevant drawing files can also be obtained from Mufeng Network (requiring specific software to open).

Detailed Assembly Step Instructions

There are certain differences in the assembly steps of different types of office chairs, but on the whole, they follow the principle of bottom-up and step-by-step installation.

• T02 Office Chair: First, place the casters one by one into the five-star base, ensuring that each caster is firmly installed. Then, place the explosion-proof gas spring into the center of the five-star base, ensuring it is vertical and stable. Next, install the armrests with screws, and install the other armrest in the same way. Pay attention to the tightness of the screws, avoiding being too tight or too loose.
• General Office Chair: Start the installation from the bottom. First, install the casters onto the chair legs, ensuring that the casters can rotate flexibly. Place the gas spring vertically into the center of the chair legs, which is the key to ensuring the normal lifting function of the chair. Fix the base to the seat with screws, paying attention to the accuracy of the screw specifications and installation positions. Connect the chair back and the seat to make them tightly connected. Insert the installed base vertically onto the gas spring, ensuring a firm connection. Finally, install the armrests and headrest, adjusting their positions according to actual needs and fixing them.
• Five-Star Base Office Chair: First, insert the casters into the holes of the five-star base, ensuring that the casters are properly installed. Turn over the five-star base and install the gas rod onto it, paying attention to the direction and position of the gas rod. Place the seat cushion on the ground and install the base. After the base is installed, place the seat cushion on the gas rod. When installing the armrests, pay attention to the accurate connection position between the armrests and the seat cushion. When installing the backrest, do not tighten all the screws to facilitate subsequent adjustment of the backrest angle. After aligning the holes of the backrest and the armrests, install the bottom and top screws and tighten them. Finally, install the armrest decorative buckles to make the chair look more beautiful.

Drawing File Acquisition

If drawing files are required, you can refer to the office desk and chair assembly drawings (including supporting designs such as computer desks) provided by Mufeng Network, but they need to be opened with Solidworks2016 software, and the file formats are sldasm and sldprt.