Rope-Woven Office Chair

The steps and key points for weaving a rope-woven office chair are as follows:

I. Initial Rope Wrapping and Fixing When weaving the chair seat, first prepare hemp rope. Wrap it around your arm about 20 times and then cut it off to serve as the initial rope segment. The wrapping direction should be from the outside in and from top to bottom. Prioritize wrapping both sides of the four corners of the chair seat to ensure the corner structures are stable. When wrapping the second time, press the new rope over the previous one. Keep the wrapping moderately loose to avoid difficulties in subsequent adjustments due to excessive tightness. After completing the initial wrapping of the corners, tighten the rope in each direction and use the high friction of the hemp rope to fix the shape. After tightening, use a clip to fix the rope end at the last corner to prevent it from coming loose during the second round of wrapping.

II. Repeated Wrapping and Layer Control When repeating the second round of wrapping, the direction should be the same as the first round (from the outside in and from top to bottom), but loosen the clip before tightening. Starting from the second round, strictly avoid rope overlapping:

• Horizontal Control: Each round of rope should not cover the trajectory of the previous round and should maintain an independent plane;
• Vertical Control: The rope should not pile up below. It should be lifted and adjusted so that each round is horizontal. When continuing to wrap until the fifth round, pause for inspection:
• Observe whether the ropes at the four corners form 90-degree right angles. If there is a deviation, place a small wooden block under the rope and tap it lightly with a hammer to make it close;
• Neaten the rope surface and tap the overlapping parts to restore flatness, ensuring the overall uniformity of the chair seat.

III. Rope Joining and Detail Handling After completing the weaving of the first rope segment, a new rope segment needs to be joined. Use a square knot for rope joining, with the following steps:

1. Determine the upper and lower ropes (e.g., purple on top and green on the bottom). Wrap the green rope around the purple rope once;
2. Press the purple rope over the green rope again and tighten it to form a stable knot. Since the chair seat has a double-layer structure, the rope joining point will be covered. Therefore, tie the knot in the middle of the rope segment to avoid discomfort when sitting. After joining the rope, leave a 1 - 2 centimeter excess and cut off the extra part.

IV. Overall Adjustment and Patient Operation During the weaving process, check the arrangement of the rope surface at any time:

• If local unevenness is found, tap and adjust it lightly with a hammer and a small wooden block. Check both the front and back sides;
• Focus on tapping the corners to ensure the right-angle shape;
• Repeat the above steps until the required number of layers is completed. Stay patient during the process to avoid rope surface disarray due to impatience.

Key Precautions:

• The wrapping direction and layer control are the keys to a flat chair seat;
• The rope joining position should be concealed and firm;
• Regular adjustments can reduce the need for rework later.