Office Chair Mesh Chair Installation

The installation steps for office chair mesh chairs vary depending on the specific model. Here are the installation methods for common models:

028 Office Mesh Chair: When installing, pay special attention to the connection between the backrest and the armrests. First, align the backrest with the armrests, ensuring they are in the correct position, and then secure them with 6 medium-length screws. During installation, it is recommended to maintain a sitting or semi-squatting position to facilitate observing the screw holes and applying appropriate force, avoiding uneven force that could cause the screws to slip or the components to misalign.

Yilai 815 Office Mesh Chair:

1. Assembly of the Five-Star Base and Wheels: Insert the wheels vertically into the slots of the five-star base, ensuring that each wheel is fully inserted and secure.
2. Seat Cushion and Footrest Handling: Flip the seat cushion over so that the back is facing up. If the chair is equipped with a footrest slider, install it at the front end of the seat cushion (note that the oblong hole should face forward); if there is no footrest, skip this step.
3. Tray Installation: Align the tray with the buckles or screw holes at the bottom of the seat cushion, ensuring that the arrow mark faces forward (usually, the arrow direction indicates the front when in use), and secure it with screws or buckles.
4. Armrests and Decorative Covers: Select screws of the corresponding size to install the armrests. When tightening, apply force gradually in stages to avoid deforming the components by tightening them all at once; finally, snap on the decorative covers and insert rubber rings at the ends of the footrests to increase friction.

Multifunctional Computer Chair:

1. Casters and Lifting Rod: Insert the movable casters into the edge slots of the five-star base, confirm that they can rotate 360 degrees horizontally, and then insert the lifting rod into the center hole of the five-star base.
2. Tray and Backrest: After flipping the chair body, snap the tray onto the top of the lifting rod, install the backrest bracket, and secure the backrest mesh with screws, ensuring that the mesh is flat and wrinkle-free.
3. Armrests and Decorations: When installing the armrests on both sides, check the direction (usually marked with “L” and “R”), tighten all the screws, and then snap in the black decorative buttons and the diamond-shaped decorative panel at the back of the backrest in sequence to complete the overall assembly.

General Precautions:

• Before installation, check all the components to avoid missing screws or washers.
• When using an electric screwdriver, control the torque to prevent over-tightening and damaging plastic components.
• After assembly, check the mobility of each component, such as whether the wheels rotate and the lifting rod adjusts smoothly.