Office Chair Leg Installation
The installation methods for office chair legs vary depending on the model, and the appropriate method should be selected based on the specific model. Here are the installation steps and precautions for common models:
The installation of the P510 wooden-leg chair requires two steps. First, align the wooden legs with the iron frame and use 8 fine short screws for initial fixation. Pay attention to matching the screw specifications during installation to avoid using screws that are too long or too short, which could lead to structural instability. After all the screws are in place, use a wrench to tighten them one by one to ensure that each screw is tightened to the same degree, preventing the wooden legs from tilting due to uneven force. Second, after installation, anti-slip pads can be added to the bottom of the chair legs. Anti-slip pads not only increase the friction between the chair and the ground to prevent sliding but also reduce noise generated during movement and protect the floor from scratches.
The core of installing the W901 split four-leg chair lies in screw selection and height adjustment. This model requires 4 extended screws to fix the split four legs separately under the seat cushion. Before installation, confirm that the screw length is sufficient to penetrate the connection layer between the seat cushion and the chair legs. If the screws are too short, the connection may become loose. After fixation, the height can be adjusted by rotating the adjustment device at the bottom of the chair legs. When adjusting, keep all four legs adjusted synchronously to avoid chair wobbling due to height differences. If difficulty is encountered during adjustment, check for foreign object blockages or thread damage, and do not force rotation.
The installation of the Xiamu Fit CC office chair is mainly of the insertion type. The first step is to directly insert five silent universal wheels into the alloy leg holes of the chair feet. Ensure that the wheel directions are consistent and the insertion depth is sufficient to prevent them from falling off during use. The second step is to place the gas rod into the reserved hole in the middle of the chair legs. The gas rod is the core component that supports the chair's lifting function. During installation, check whether the surface of the gas rod has scratches or deformations. If defects are found, it should be replaced; otherwise, it may affect the lifting function or pose safety hazards.
Installation suggestions for unmentioned models: If the office chair model is not within the above range, it is advisable to first check the product manual or contact after-sales service for installation guidance. Before installation, clean all parts to avoid debris affecting the connection effect. When using tools, control the force to prevent scratching the chair surface or damaging the threads. If blockages or mismatched parts are encountered during installation, stop the operation immediately and investigate the cause. Do not force assembly.
