Office Chair Installation Steps Diagram

There is no direct installation steps diagram for office chairs, but you can refer to the following detailed textual descriptions of installation steps:

TOAI E1 Office Chair Installation Steps:

• Install Wheels and Gas Cylinder: Press the wheels into the chair corners, ensuring each wheel is firmly installed. Then, place the gas cylinder into the central hole of the five-star base, paying attention to the direction of the gas cylinder, with the thicker end generally facing downwards.
• Connect Seat Cushion and Backrest: Take out the seat cushion and backrest, and secure the backrest with three M8 screws. Tighten the screws to ensure a stable connection between the backrest and the seat cushion.
• Install Armrests: Connect the armrests to the seat cushion, flip the chair seat, and secure the other armrest. Pay attention to the front, back, left, and right directions of the armrests during installation.
• Install Footrest: Take the footrest and insert it into the hole beneath the seat cushion, ensuring it is fully inserted.
• Insert Gas Cylinder into Base: Align the gas cylinder with the base and insert it, paying attention to the direction of the base.
• Install Headrest: Finally, insert the headrest into the backrest, completing the chair installation.

Common Office Chair Installation Steps:

• Install Wheels and Gas Rod: Insert the wheels into the five-star base, applying a bit of force. Some wheels may need to be screwed in. After installing the wheels, flip the five-star base over and place the gas rod into the central hole. Remove the gas rod cap before insertion (if there is a three-section sleeve, insert it into the gas rod).
• Install Base and Seat Cushion: Place the seat cushion on a clean floor to install the base. Pay attention to the direction of the base during installation and tighten the screws. After installing the base, place the seat cushion on the gas rod and insert it into the base hole.
• Install Armrests and Backrest: After placing the seat cushion on the gas rod, start installing the armrests, paying attention to their front, back, left, and right directions. Do not fully tighten all the screws of the armrests. Place the backrest on the seat cushion, paying attention to its direction. First, align the holes of the backrest with those of the armrests, then install the screws on both sides of the bottom of the backrest without fully tightening them. After installing the bottom screws, lift the backrest to install the top screws. After installation, tighten all the screws.
• Install Armrest Decorative Covers: After tightening all the screws, install the armrest decorative covers.

Installation Steps for Sihoo Ergonomic Chair and Luban Home Office Chair: The overall approach is similar to the above, starting with installing the chair feet and gas rod, followed by the base and seat, then connecting the backrest, and finally installing the armrests and headrest. However, there may be slight differences in specific operational details and screw specifications.