Office Chair Installation Guide

The installation methods vary for different types of office chairs. Here are the installation steps for several common office chairs:

Installation of Deli Office Chair

• Installation of the Exhibition Bead: Installing the exhibition bead is relatively easy. Press its internal structure in and apply a bit of force to secure it in place. This step is relatively simple, mainly utilizing the design features of the exhibition bead itself to fix it by pressing.
• Seat Installation: First, place the seat steadily at the bottom. Push the screws up. This office chair has 8 screws. Install them according to the指示箭头 (instructional arrows) on the front. Install some of the screws first and do not tighten them all at once for subsequent adjustments.
• Backrest Installation: When placing the backrest, screw installation is involved. Slightly bend the backrest before operating. Pay attention to the force during installation to avoid damaging the backrest or the screws.
• Decorative Cover Installation: Finally, install the decorative cover. The decorative cover can beautify the office chair and also protect internal components such as screws. Ensure that the decorative cover fits tightly against the surface of the office chair during installation.

Installation of 1012A Office Chair

• Material Preparation: Prepare the required materials and tools before installation to ensure a smooth installation process.
• Base Caster Installation: First, install the base casters, which are the basic components for the office chair to move flexibly. Pay attention to the direction and position of the casters during installation to ensure they can rotate normally.
• Seat Armrest Installation: Install the seat armrests using screw C according to the video instructions, and install screw D on the inner side. Pay attention to the angle and height of the armrests during installation to make them ergonomic and provide comfortable support.
• Installation of Other Base Components: Put screw E into the washer and then insert it into the base. Pay attention to the tightness of the screws in this step to avoid affecting the stability of the office chair due to being too loose or too tight.

Installation of Another Type of Office Chair

First, place iron pellets in the holes of the two crossbeams. The horizontal lines of the iron pellets should face the exit position on the other side. After placing the iron pellets, use long screws for operation. The key to this step lies in the placement position of the iron pellets and the installation of the long screws. Ensure that the iron pellets are placed accurately and the long screws can firmly connect the crossbeams to ensure the structural stability of the office chair.