Office Chair Foot Replacement

The methods for replacing office chair feet vary depending on the type of chair foot. Here are the replacement methods for common types of chair feet:

Footrest Replacement for Sihoo C Series (C300C500)

Replacing the footrest for the Sihoo C Series (C300C500) is relatively simple. First, prepare a piece of foam and place it on the ground. Place the chair on the foam to prevent the chair back from scratching the ground during the replacement process. Then, locate the three screws securing the footrest and use an appropriate screwdriver to remove them one by one. After removing the screws, you can easily take off the old footrest and replace it with a new one. Finally, tighten the three screws again to ensure the footrest is firmly secured.

Installation of F28 New Inclined Leg Chair Feet

The installation steps for the F28 new inclined leg chair feet are more complex. Step 1: First, unscrew the reserved screws on the footrest frame; then, align one side of the footrest frame with the steel tube on the other side and insert it, using a wrench to tighten the reserved screws one by one. Step 2: Align the angle iron with the holes on the foot pedal, use four thin and short screws to secure the angle iron to the foot pedal, and tighten the screws one by one with a wrench. Step 3: Align the other side of the angle iron with the holes on the footrest frame, use four thick and medium screws to secure the other side of the angle iron to the footrest frame, and then insert the knob into the hole on the footrest frame. Step 4: Align the armrests with the holes on the backrest and seat cushion, and secure them with four thin and short screws and four thin and medium screws respectively. The final step: Align the footrest frame with the holes on the seat cushion and secure the footrest frame to the seat cushion with four thin and extended screws. If the chair feet wobble after installation, you can install foot nails to level them. First, put two washers on the foot nails, then align the foot nails with the bottom of the chair feet and tighten them, and install the other side in the same way. If there is still slight unevenness, slightly rotate the foot nails on one side to adjust.

Replacement of Computer Chair Five-Star Feet

To replace the five-star feet of a computer chair, first gently lay the chair on the ground and check if there is a flat washer snap ring at the bottom of the central column. If there is a flat washer snap ring, use an appropriate tool to remove it, then pull out the old five-star feet and replace them with new ones. If there is no flat washer snap ring, the connection between the five-star feet and the steel column is conical and pressed together by weight. In this case, you can gently tap it with a hammer until the five-star feet come off, and then install the new five-star feet.