IKEA Office Chair Lomfjord Disassembly and Washing

The disassembly and washing of the IKEA office chair Lomfjord can be carried out according to the following steps:

I. Preparing Tools The Lomfjord chair comes with two hex wrenches, usually stored in the pull cord under the seat. In addition, prepare a rubber mallet (or an ordinary hammer with a thick cloth), work gloves, and a thick cloth or old towel. Having all the tools ready can prevent damage to the components or scratches to your hands during the disassembly process.

II. Disassembly Steps

1. Disassembling the Armrests (if applicable) Check the connection between the armrests and the main body of the seat. Use a hex wrench of the appropriate size to turn the internal hex screws counterclockwise and remove the armrests. Keep the screws safe to avoid losing them.
2. Disassembling the Seat and Backrest Assembly Place the chair on its side or upside down. Locate the fixing screw connecting the top of the gas lift rod at the center of the bottom of the seat. Completely remove the screw with a hex wrench, and then lift the entire seat (including the backrest) part away from the gas lift rod.
3. Separating the Gas Lift Rod
   • Single-person Operation: Place the chair on its side. Press down on the height adjustment lever under the seat with your left hand. Use a hammer (with the hammerhead wrapped in a thick cloth or placed on the striking area) to strike the metal ring at the connection between the gas lift rod and the five-star base hard, making it loose and fall off.
   • Two-person Operation: Two people hold the two sides of the five-star base steady, and another person holds the upper part of the gas lift rod of the removed seat. Shake it evenly from side to side and pull it upward, using skill to separate them.
   • Alternative Plan: Adjust the seat to the highest position and then lay it down. Gently tap the gas lift rod body with a hammer. Then, place a thick cloth at the connection between the gas rod and the base. Lift the footrest to make the seat cushion leave the ground. Strike the padded area evenly to make the gas rod and the footrest fall off together.
4. Disassembling the Five-star Base Turn the five-star base upside down on the ground (pad it with a soft cloth). Use a rubber mallet to strike evenly around the steel ring connecting the center of the base to the gas lift rod. After striking, try to pry the base. If it is still firmly attached, continue striking.
5. Disassembling the Casters Turn the chair upright. Grasp the wheels with your hands and pull them outward forcefully. If they cannot be pulled out, use a screwdriver or a hex wrench to hold the edge of the wheels. Lay the chair horizontally and hold the wheels with both hands, with the lower hand pulling downward forcefully to remove them.

III. Cleaning the Components Use a vacuum cleaner to clean the dust on the surface of each component, and then wipe them with a cloth dampened with water. Avoid using corrosive cleaners. After cleaning, place them in a cool and well-ventilated place to dry naturally. Direct sunlight is prohibited to prevent plastic or fabric components from cracking and deforming.

IV. Reassembly Reassemble step by step in the reverse order of disassembly: first install the casters → the five-star base → the gas lift rod → the seat and backrest assembly → the armrests. When assembling, ensure that the screws are tightened and the components are firmly connected to avoid looseness or abnormal noises after use.