Electric Office Chair Assembly

The assembly methods for electric office chairs vary depending on the model and design. Common assembly methods can be divided into the following four categories:

1. Assembly Steps for the E108D Electric Model
First, install the five-star base and insert the gas lift vertically into the center hole of the base, ensuring a secure connection between the gas lift and the base. Next, attach the seat body to the footrest, aligning the backrest with the pins on the seat and gently pressing until fully engaged. Then, install the headrest. When connecting the wires, follow the sequence: first insert the battery wire, then connect the backrest function wire, and finally check that the wires are properly connected to avoid short circuits or poor contact. Finally, install the armrests, using the provided screws to tighten and secure them, ensuring no wobbling.

2. Steps for Converting the Xiaopeng X9 Co-Driver Seat into an Electric Office Chair
The conversion begins with power installation: connect the 2005431-1 male plug to the DC female port, attach a 12V battery, and test the electric forward and backward movement function to confirm it works properly before proceeding. When installing the armrests, pay attention to the left and right markings on both sides of the aluminum plate to avoid installing them backward. The square bracket base should be fixed in the center of the aluminum plate to ensure even force distribution. When attaching the steel frame to the underside of the seat, use screws to secure the four corners of the seat to the aluminum plate, ensuring structural stability. Finally, install the wheels onto the seat bracket base and test for smooth rolling.

3. Assembly Steps for a General-Purpose Electric Office Chair
Adopt a bottom-up assembly logic: first, attach the casters to the chair legs, ensuring the caster clips are secure. Then, place the gas lift vertically into the center of the chair legs, avoiding tilting to prevent damage to the gas lift. The base plate should be fixed to the bottom of the seat, and when connecting the backrest to the seat, ensure the pins are aligned. After inserting the base vertically into the gas lift, gently shake it to test the connection stability. Finally, install the armrests and headrest, tightening the armrest screws until they are secure without any looseness, and adjust the headrest angle as needed.

4. Assembly Steps for a Multi-Functional Computer Chair
After inserting the movable casters into the five-star base, insert the lift rod and test the lift function to ensure it works properly. When attaching the computer chair tray, align it with the slots. After installing the backrest bracket, secure it with screws to prevent it from coming loose during use. When installing the armrests on both sides, pay attention to the direction to avoid affecting arm support comfort. After tightening all the screws, attach the decorative buttons and the diamond-shaped decorative panel on the back of the backrest to enhance aesthetics and protect the internal wiring.

Assembly Precautions:

• Before assembly, check the parts list to avoid missing key components;
• Tighten the screws with moderate force. Over-tightening may cause the screws to strip, while under-tightening affects stability;
• Connect the electric components strictly according to the instructions to prevent short circuits or functional abnormalities;
• After assembly, test all functions (such as lifting, rotation, electric adjustment, etc.) to ensure normal use.