Double Office Chair Handmade

You can refer to the following several handmade methods for making double office chairs, with specific steps and key points as follows:

1. Transform old chairs into double cement seats
This method is suitable for creative transformation using idle old chairs. First, use an angle grinder to cut off one support leg of one of the chairs, ensuring a flat cut. Drill round holes of an appropriate diameter in the adjacent chair legs with an electric drill, and connect and fix the two chairs with iron wire to form the basic framework of the double seat. Then, completely immerse a bedsheet in cement mortar to ensure it fully absorbs the cement, and then cover it over the chair framework, adjusting the shape to fit the seat surface and backrest. After the cement is completely dry, remove the bedsheet template to obtain a double cement seat with an industrial style. Key points: The proportion of the cement mortar should be appropriate to avoid insufficient strength due to being too thin; keep the environment well-ventilated during the drying process to prevent cracking.

2. Make double seats from old wheel hubs and wooden boards
This method uses old car wheel hubs as the main structure of the seat. First, fix two wooden boards diagonally below the wheel hub as support legs to ensure a stable angle; install spliced wooden boards (such as multi-layer boards or solid wooden boards) on the rims on both sides of the wheel hub, and fix them with screws or nails to form the seat surface; fix narrow wooden strips on the front and rear support legs with nails as footrests or decorations. Key points: The wheel hub should be clean and rust-free, and the spliced parts of the wooden boards should be polished flat; the angle of the support legs should be tested to ensure the stability of the seat's center of gravity.

3. Make double armchairs with long wooden boards and square wooden bars
This method uses wood as the main material and is suitable for users who pursue a natural style. First, use a long wooden board as the seat surface, and nail four square wooden bars into a rectangular frame as the chair legs and crossbeams; after standing the frame upright, fix wooden boards diagonally on the inside of the square wooden bars as triangular supports to enhance structural stability; finally, process the two sides, such as installing backrests or armrests. Key points: The wood should be a dry and crack-free variety; the nails or screws should be of a specification that matches the thickness of the wood to avoid loosening.

4. Make double wooden chairs from waste wooden pallets
This method achieves environmentally friendly production by recycling waste wooden pallets. First, assemble long wooden strips into a rectangular frame and fix them with screws or nails; install four thick wooden legs at the four corners of the frame to ensure structural stability; lay wooden boards on the frame as the seat surface and nail them tightly with a hammer, and add crossbeams if necessary to enhance the load-bearing capacity. Key points: The wooden pallets should be checked for no insect infestation or decay; the spliced parts of the wooden boards should be staggered to prevent an uneven sitting feeling.