Creative Office Chair Installation

The installation of a creative office chair should be carried out according to standardized steps. The specific process is as follows:

1. Install the Chair Wheels Insert each of the five swivel casters into the mounting holes of the five-star base one by one, ensuring that each caster is fully secured to prevent looseness. After installation, gently shake the five-star base to check if the casters are stable, preventing abnormal sliding during subsequent use.

2. Secure the Gas Lift Cylinder Turn the five-star base upside down with the casters facing downwards, and vertically insert the thicker end of the gas lift cylinder into the center hole of the five-star base. For some models, the lifting rod needs to be directly inserted into the middle hole of the five-star base; refer to the instruction manual to confirm the specific structure. Note: The gas lift cylinder is the core component that supports the seat's height adjustment; ensure that it is inserted deeply enough and without any deviation.

3. Connect the Seat Base and Cushion Place the seat base on the bottom of the cushion, align the screw holes, and initially screw in four long screws (B screws) 3-4 turns, then tighten them one by one until they are fixed. Avoid cross-tightening the screws in this step to prevent uneven force on the seat base, which could cause the cushion to tilt.

4. Assemble the Backrest

   • Align the bottom sides of the backrest with the mounting positions on both sides of the cushion armrests and slowly insert them until they are fully fitted.
   • Use two C screws to secure the bottom of the backrest from the bottom of the armrest brackets, then use D screws to lock the backrest and cushion brackets together with a wrench, ensuring that there is no wobbling at the connection points.
   • For some models, the backrest mesh needs to be fixed to the brackets with screws; choose the appropriate screws according to the backrest structure.

5. Install the Armrests Press the button below the armrest surface, and insert the left and right armrests into the armrest bracket holes respectively, paying attention to the directional indicators (such as 'L' and 'R' markings) to avoid incorrect installation. After insertion, test whether the button functions normally to ensure that the armrests can be flexibly adjusted in height or angle.

6. Secure the Headrest Place the headrest in the middle position at the top of the backrest, press it to fit the curvature of the backrest, and tighten it with two E screws through the fixing clips. Key Check: Ensure that the gap between the headrest and the backrest is even to prevent tilting and affecting comfort during use.

7. Final Adjustment After tightening all the screws, check that all component connections are secure and attach decorative buttons or diamond-shaped decorative plates (if any). For advanced models that support sitting and reclining functions, focus on testing the smoothness of the gas lift cylinder's height adjustment and the stability of the backrest locking mechanism to ensure there is no jamming or abnormal noise.

Tip: It is recommended to watch video tutorials (such as those provided by Luban Home Services) before installation and verify the screw usage instructions to avoid misuse that could damage components. If the screw holes do not align or components are stuck, do not force assembly; contact after-sales service to troubleshoot the issue.