Cat Office Chair Tutorial

Currently, there is no complete tutorial specifically for a 'cat office chair,' but it can be achieved by modifying similar DIY plans. Here are three feasible approaches:

Early Summer Cool Chair Modification Plan (Suitable for Summer Use)

Core Materials: Regular office chair, aluminum disc (slightly larger in diameter than the chair surface), nano tape (or double-sided tape), scratch-resistant fabric.

1. Fixing the Aluminum Disc: Clean the dust from the chair surface. Apply nano tape along the backrest and both side edges (if the chair surface is smooth and minor damage is acceptable, double-sided tape can be used as an alternative) to form a 'U'-shaped sticking area. Place the aluminum disc in the center, press gently to ensure full contact with the tape, and shake to check for stability.
2. Covering with Scratch-Resistant Layer: Cut a piece of scratch-resistant fabric (such as sisal cloth) that is 10-15 cm larger than the aluminum disc and lay it flat on the disc's surface. Use large clips to secure the fabric's edge along the backrest and small clips at intervals along the junction of the disc and fabric. Ensure the clips open outward to prevent the cat from being pinched during activity.
3. Safety Optimization: Check if the edges of the aluminum disc are smooth. If there are burrs, sand them down. Regularly check the tape's adhesion to prevent the disc from falling off.

Cat Stool DIY Plan (Suitable for Long-Term Use)

Core Materials: Wooden board (with a 70-degree bevel), metal stool legs (two angled and two straight), lamb's wool fabric, medium-density foam.

1. Stool Surface Creation: Cut the wooden board into a trapezoid (top width 30 cm, bottom width 40 cm, height 25 cm). The beveled design conforms to a cat's lying habit. Cut the foam to the same size as the board and fix it to the board's surface with spray adhesive.
2. Stool Leg Installation: Drill holes at the four corners of the board, insert the metal stool legs (with the angled legs facing forward for enhanced stability), and secure them with screws. Add rubber pads to the bottom of the legs to prevent slipping and protect the floor.
3. Fabric Wrapping: Lay the lamb's wool fabric face down flat, place the stool surface (including foam) in the center, wrap the fabric upwards around the sides, and sew it. Leave an opening at the stool legs, and after installation, wrap the fabric around the bottom of the legs to prevent metal from directly contacting the ground, which could cause noise or wear.

Woven Cat Resting Seat Plan (Suitable for Multi-Functional Use)

Core Materials: Old plastic stool, cotton rope, heated fork, openable curtain.

1. Weaving the Support Layer: Use the heated fork's tip to evenly punch holes in the stool surface (hole spacing 3-5 cm). Thread the cotton rope from the bottom through the holes and weave a grid using the 'warp and weft interlacing method.' Adjust the grid density (densify the center area to a 2 cm hole spacing) to form a concave support area.
2. Installing the Curtain: Attach the hook side of Velcro around the stool. Cut four pieces of curtain (slightly larger than the stool surface) and sew the loop side of Velcro along the edges. When the curtain is pulled up, it can be fixed with ties to form a semi-enclosed space. When laid down, an old blanket can be placed on it as a private resting area for the cat.
3. Safety Inspection: Ensure the cotton rope is tightly woven with no loose knots. After fixing the curtain, leave breathable gaps to prevent the cat from suffocating.

Precautions:

• All plans should avoid using small parts (such as screws, clip heads) to prevent the cat from swallowing them.
• Regularly check the wear and tear of materials and replace aging parts promptly.
• Adjust the dimensions according to the cat's size. For large cats, increase the diameter of the chair surface or the load-bearing capacity of the stool surface.