Aurora Office Chair Recovery

The steps to recover an Aurora office chair that is leaning to one side are as follows:

Step 1: Check the wheel status and floor flatness
First, place the chair upright and upside down to observe whether the wheels are in even contact with the floor. If there are any wheels not touching the floor, check if the floor is flat. If the floor is fine, turn the chair upside down and carefully inspect each wheel for signs of bending, deformation, or breakage. If the wheels are damaged, purchase a new wheel set that matches the original wheels for a complete replacement to avoid continued leaning after recovery due to inconsistent wheel specifications.

Step 2: Remove the old wheels (if replacement is needed)
If the wheels are damaged and need to be replaced, first turn the chair upside down or sideways for easier operation. Most wheels are secured with clips and can be pulled out by hand. If the clips are too tight, use a flat-head screwdriver inserted into the gap between the wheel and the base as a lever for removal. A very small number of wheels are secured with screws, in which case use a screwdriver to loosen the screws and then remove the wheels. Be careful with the force applied to avoid damaging the base socket.

Step 3: Lubricate the base socket and wheel axle
Spray a small amount of spray lubricant (such as WD-40) into each wheel socket on the chair base. If lubricant is not available, use a cotton swab to apply a pea-sized amount of petroleum jelly to the wheel axle. Lubrication reduces the friction during wheel installation, ensuring that the wheels fit snugly against the base and avoiding improper installation due to jamming.

Step 4: Install the new wheels
Align the rod of the new wheel with the base socket and try to install it by gently pushing with your hand. If the wheel is not fully seated, use a rubber mallet (avoid using a metal hammer) to gently tap the top of the wheel to fully insert the rod into the base. When tapping, keep the wheel perpendicular to the base to prevent the rod from bending or the base from being damaged. After installation, check if the wheels can rotate freely.

Step 5: Test and further troubleshoot
Place the chair upright, sit on it, and move slowly to observe whether it rolls smoothly and no longer leans. If the problem is solved, the recovery is complete; if it still leans, check if the seat plate is damaged. Turn the chair sideways, locate the metal seat plate (usually a square black painted steel plate), and check for deformation, cracks, or loose connectors. If the seat plate is damaged, contact a professional repair technician for replacement.