Anji Office Chair Assembly

The assembly of Anji office chairs can be carried out by referring to the following steps, based on the installation process of Anji Shiyi foreign trade office chairs and conventional office chair installation tutorials, to ensure a standardized and safe assembly process:

1. Preliminary Preparation and Part Verification Before assembly, place all parts and tools (such as screwdrivers and wrenches) on a flat surface, and focus on checking for missing parts. Refer to the installation requirements of Anji Shiyi foreign trade office chairs to confirm that the quantities of key components such as screws, T-bars, casters, gas cylinders, seats, and backrests match those specified in the instructions. If any parts are found to be missing or damaged, contact the supplier immediately for replacement to avoid work stoppages.

2. Basic Structure Assembly

• Caster and Five-Star Base Installation: Align the casters with the slots on the five-star base and press firmly until they are fully embedded, ensuring that each caster rotates smoothly and without looseness.
• Gas Cylinder Fixation: Insert the gas cylinder vertically into the center hole of the five-star base and press lightly until it is securely fastened at the bottom. The gas cylinder is the core component for adjusting the seat height, so check that its surface is free of scratches or leaks.
• Seat Connection: Align the metal plate at the bottom of the seat with the top of the gas cylinder and secure it with the provided screws. Note that the screws should be tightened in stages: first, loosely fasten all screws, then tighten them one by one to prevent the seat from tilting.

3. Backrest and T-Bar Installation

• T-Bar Positioning: Refer to the special requirements of Anji Shiyi foreign trade office chairs and place the T-bar with the small pit facing upwards, a design used to fix the backrest angle. Insert the T-bar into the dedicated slot at the rear of the seat, ensuring that the catch is fully engaged.
• Backrest Fixation: Align the metal bracket at the bottom of the backrest with the T-bar and insert screws from the rear of the backrest and tighten them. Two-person collaboration is required: one person holds the backrest steady while the other operates the screwdriver to prevent the backrest from shifting and causing the screws to slip.

4. Detail Adjustment and Function Testing

• Armrest Installation (if applicable): Align the armrests with the reserved holes on both sides of the seat, secure them with screws from the bottom up, and adjust the armrest height to be parallel with the seat.
• Overall Inspection: Shake the chair to test its stability, checking that all screws are tightened, the casters rotate smoothly, and the gas cylinder lifts and lowers flexibly.
• Function Testing: Sit on the chair and repeatedly adjust the height and backrest angle to confirm that there are no unusual noises or jams. If any abnormalities are found, recheck the screws or connectors in the corresponding areas.

Precautions: Wear gloves during assembly to prevent scratches and avoid using excessive force that could deform the parts. For complex structures (such as the linkage mechanism of a reclining office chair), it is recommended to refer to the official video tutorial or contact customer service for guidance. After assembly, regularly check the tightness of the screws to extend the lifespan of the chair.